Last edited by Modificatorul,
I'm glad to hear that you received confirmation, I wanted you to contact Matt because I was afraid you will ruin the tegra Soc, i hope you solve the problem.Team Xecuter got back to me and you were right about what I needed, so again thank you for the help.
Can anyone help me with the one pointed by the red arrow?
I pried the connector in the wrong way and this one is now missing. I tried measuring it on my good switch and it seemed to have no continuity at all, like an open line. However it doesn't look like a capacitor either. I also have not been able to observe any ill effect after missing it.
Thank you! I don't know what happened to my multimeter. Probably the probes wasn't getting a good contact.
My multimeter tops at 2000K. For sure I tried this stop since nothing came up for the others, but couldn't get any reading.Set your multimeter to resistance and move the dial until you read something , on my crap unit ut50b i gett a reading on this resistor only on 200M range
yes, @Pintglass if you have time can you messure with your multimeter and confirm is 130 kohm or close, thank you.My multimeter tops at 2000K. For sure I tried this stop since nothing came up for the others, but couldn't get any reading.
If it was 0.13M/130K, I should be able to get a reading, right?
https://www.molex.com/molex/products/part-detail/pcb_receptacles/5009130302I need the EMMC FPC Connector, but i cant find it on the web.
MAX17050Anyone got an idea as to what this 3*3 BGA chip is?
Pulled from the site you see here on a HAD-CPU-01 board, and with the markings +ALJ 807
View attachment 215664
I'm on the same boat, short of replacing the microsd lego slot on motherboard side, trying to figure out if one of the components is bad.
I doubt it. The other MAX 17050 chip on the board is clearly marked. This one is on the opposite side of the board. Are you sure? On another card of same design, they are named +ALJ920Anyone got an idea as to what this 3*3 BGA chip is?
Pulled from the site you see here on a HAD-CPU-01 board, and with the markings +ALJ 807
View attachment 215664
MAX17050
Oh, sorry, I read it wrong.I doubt it. The other MAX 17050 chip on the board is clearly marked. This one is on the opposite side of the board. Are you sure? On another card of same design, they are named +ALJ920
View attachment 217984
On a newer board, HAC-CPU-10, this is what they use in its place. Voltages shown are with only 5V USB charger inserted to plain mainboard with no battery or other things connected. Another place suggest som kind of buck/boost converter from Maxim (future Analog Devices).
.View attachment 218011