Switch Oled RP2040 don' t glitch, but value D, A, C are correct

[Mauroz]

Hi at all, i' m trying install RP2040 into switch Oled, i have this value with tester in diode mode.
3,3V 820
C 730
A 724
D 728
B 1250

If i try turn on see one blink blue color and after some blink green while console is truning on normally mode.
RP2040 beore install flashed with fw_2.74.uf2

 

[jkyoho]

show you installation and soldering photos

 

[zamastyle]

Does the console boot to the nintendo logo immediately? Or does it boot to the nintendo logo after the green flash?

If it boots before the flashes are complete then as jkyoho mentioned, we need to see pics of the install because that is likely an install issue.

If it doesnt boot normal firmware until after the green flash, then it may be a software setup issue.

 

[Mauroz]

Thanks for reply. The problem was dat= adapter because other Oled modded work with dat0 value aroun 715, and this Oled now work with dat0 value 466. Thanks again