Hello, today i soldered and installed my firs Switch modchip. I measured all the values - A, C, D, 3,3v were fine: 0.500-0.900v. Only B point’s (RST) value was incorrect. I know it should be 0 or 2.9v but in my case it was something like 1.1v. I tried to resolder it but nothing changed so I installed it as it was, set up and tried turn on the console. Unfortunately the console did not started, there was only black screen and chip did’t get any flash light. I heard that something was working inside when I pressed start button- it was silently buzzing until I turned it off by long pressing power button. The situation is very weird for me because the B point shows 0 value on motherboard and 1.1v when it is connected to the chip but it is not all… When I measure value of B point directly on the chip even if it is not connected to the console’s motherboard it shows the same value - 1.1v. I thought it could be caused by wrong soldered cpu flex tape but everything seems good. Outside capacitors gives 0v and inside ones gives something like 13v. insides and outsides cpu capacitors beeps as well when being measured. I have no idea what is going on. I will be very grateful for every response.
There is a possibility that I have done a bad installation. I thought there are the same points for every kind of mod chips for switch Oled and now I see that It may not be true. As you can see with the chip I got a flex tape like that and there is different b point than I can see on YouTube videos. I have done this installation with this YouTube video:
Post automatically merged:
There is a possibility that I have done a bad installation. I thought there are the same points for every kind of mod chips for switch Oled and now I see that It may not be true. As you can see with the chip I got a flex tape like that and there is different b point than I can see on YouTube videos. I have done this installation with this YouTube video:
Attachments
Last edited by Consoledestroyer,