I have a weird issue.
I think that maybe just my joycon pin is soldered wrong.
I am using a trinket m0.
Ground is soldered from Gnd to the alternative ground near the switch battery wire.
Usb wires are in the normal location.
vol+ is soldered to point 0.
3 volt is on the underside of the nand chip
Point 3 on trinket is soldered to pin 10 on the physical joycon rail.
I can not figure out how to use the trinket to enter RCM.
the data wires, ground, and 3v are working because I can update the trinket UF2 from the usb-c port on the switch.
The vol+ is working because when I press it, the trinket has a red led turn on.
The means there must be something wrong with the joycon strap.
I am using the tiny gauge magnetic wire for this one.
I tried:
All three joycon strap points and trimming the magnetic wire shorter.
The only way I can enter RCM is to pull the nand, and after power on and reinsert, I am greeted with hekate pushed by the trinket.
Any ideas as to what I might be doing wrong?
--------------------- MERGED ---------------------------
I have a weird issue.
I think that maybe just my joycon pin is soldered wrong.
I am using a trinket m0.
Ground is soldered from Gnd to the alternative ground near the switch battery wire.
Usb wires are in the normal location.
vol+ is soldered to point 0.
3 volt is on the underside of the nand chip
Point 3 on trinket is soldered to pin 10 on the physical joycon rail.
I can not figure out how to use the trinket to enter RCM.
the data wires, ground, and 3v are working because I can update the trinket UF2 from the usb-c port on the switch.
The vol+ is working because when I press it, the trinket has a red led turn on.
The means there must be something wrong with the joycon strap.
I am using the tiny gauge magnetic wire for this one.
I tried:
All three joycon strap points and trimming the magnetic wire shorter.
The only way I can enter RCM is to pull the nand, and after power on and reinsert, I am greeted with hekate pushed by the trinket.
Any ideas as to what I might be doing wrong?
Nevermind, I just replaced with a thicker wire and now it works. Weird.