Installed into a lite today to the best of my current ability. So far it just blinks red once like after programming but nothing after and nothing on screen.
I put it to single, but also tested with 3 & 4 both booted switchI couldn’t RESIST lol did you bridge the pins on the flex? Or left as is
Sent from my iPhone using Tapatalk
Installed into a lite today to the best of my current ability. So far it just blinks red once like after programming but nothing after and nothing on screen.
One np2016 works for oled soI'd like to know this too
I couldn’t RESIST lol did you bridge the pins on the flex? Or left as is
Sent from my iPhone using Tapata
Doesn't pico control the gate? I vaguely remember binkinator saying thatim not sure but it seams to me the cables from the mosfet need to be turned around D to left side of cap and G to right side of cap and the cpu cabel (s) is under ground and u connectet ur cpu cabel to D
https://gbatemp.net/attachments/mariko-jpg.360376/
ExactTo use this on a Mariko all I need is a rp2040zero, a hwfly v2 cable and a couple of 47ohm smd resistors correct?
D left side of cap G right side cap s to rp2040Doesn't pico control the gate? I vaguely remember binkinator saying that
Most likely notOkay it's a Sk hynix.... Will i have issues with PicoFly or Hwfly?
This is wrong,D left side of cap G right side cap s to rp2040
true srry my mistake .This is wrong,
Gate goes to Pico
It's been clarified many times before that this picture was wrong.
Cap is source and Drain
@linuxares is it possible to edit the original post of this image saying it is wrong? I remember seeing it maybe a dozen pages ago but can't find it. Maybe it could help for the people to not repeat the same mistake again and again...
Is the removed cap just bridged?D left side of cap G right side cap s to rp2040
Post automatically merged:
My install but i had to install 2 mosfets
View attachment 361354
No I put uv mask on the solder point under the mosfetIs the removed cap just bridged?
Also I removed CMD point and it boots ofw, but with cmd connected it does nothing
Ok, thought you might say thatno there is no way to bypass the mosfett
blue then toruise(cyan) that mean u have a issue with the mosfet or cable to mosfett
u can use a short thick wire or repair pads for broken traces
lets see a pic of ur soldering and ur tip ,are u using flux ?