NOTE
This file should only be used for @Wesleyy's 2DS because it has his console unique hardware calibrations. To other people with 3DS systems where the 3D mode is stuck, you should not borrow @Wesleyy's file because this might cause weird hardware behaviors.
***
Edit - OP resolved his 3D mode brick; removed the ZIP archive from my post.
This file should only be used for @Wesleyy's 2DS because it has his console unique hardware calibrations. To other people with 3DS systems where the 3D mode is stuck, you should not borrow @Wesleyy's file because this might cause weird hardware behaviors.
***
4. Download the fixed config save.zip found below this post. Once it is in your possession, I will delete it from my post.
5. Extract the 00000000 from the ZIP with one of mentioned programs from post #75. Put the file on your SD card. Reinsert the SD card to the 2DS.
6. Launch GodMode9. Navigate to that file wherever it was placed under the [0:] SD CARD () drive.
7. Press (Y) on 00000000 to [CLIPBOARD] select the file; see the bottom screen's upper right corner.
9. Press (A) on the 00000000 → Calculate CMAC → <A> yes → <A> yes → button combo → <A> yes.
10. Press (START) to boot to HOME Menu.
***5. Extract the 00000000 from the ZIP with one of mentioned programs from post #75. Put the file on your SD card. Reinsert the SD card to the 2DS.
6. Launch GodMode9. Navigate to that file wherever it was placed under the [0:] SD CARD () drive.
7. Press (Y) on 00000000 to [CLIPBOARD] select the file; see the bottom screen's upper right corner.
- If a mistake occurred, press (SELECT) to reset selection.
9. Press (A) on the 00000000 → Calculate CMAC → <A> yes → <A> yes → button combo → <A> yes.
10. Press (START) to boot to HOME Menu.
Edit - OP resolved his 3D mode brick; removed the ZIP archive from my post.
Last edited by TurdPooCharger,