[backstory]
So I've been using USB launcher GX for a while and it was working great, but I was getting some new games in and my flash drive was filling up.
I had an sd card for my GC games but that was almost full too. I was going to just get a hard drive or a bigger flash drive, but with smash4 around the corner I'd need two open usb ports for the controller adaptor, and one for the usb-Ethernet, and one for my wiiU installs.
After doing some reading I found out that you can load both wii and GC games from an sd card, and it's supposedly faster then USB.
So I went out and got a 64gb PNY class 10 SD card.
[The problem]
I loaded up all my games using the same folder structures as before,
but when I loaded up usb loader gx, I found that it would only read GC games from the SD card.
I then tried wiiFlow, as it's supposed to read from both, and it did, but when I try to load the games it just goes to a black screen
I then tired CFG loader mod, and It was also able to see the files, but it just refused to launch the wii games.
(gc games through nintendon't still load)
but it at least gave me an error message:
iso (249)
Iso reload: blocked
error: setting up fragments -2 3
ID mismatch [RSPE01] []
Error: SetWBFS: -3
I've googled the error, and tired (almost) all the suggestions
(obviously not the installing original wii cios stuff)
one person suggested turning 'block ISO load' to 'off'
Doing so give the same error, but without the 'Iso reload: blocked'
All the games are clean dumps that I've done myself and tested.
I even retested by coping the files from the sd card back to a flash drive,
and USB loader GX had no trouble launching them.
I even tried a suggestion of re-installing d2x cIOS
as shown here:
https://gbatemp.net/threads/simple-guide-to-install-cios-on-vwii-backup-nand-and-keys.339890/
but the problem still remains.
Any ideas?
So I've been using USB launcher GX for a while and it was working great, but I was getting some new games in and my flash drive was filling up.
I had an sd card for my GC games but that was almost full too. I was going to just get a hard drive or a bigger flash drive, but with smash4 around the corner I'd need two open usb ports for the controller adaptor, and one for the usb-Ethernet, and one for my wiiU installs.
After doing some reading I found out that you can load both wii and GC games from an sd card, and it's supposedly faster then USB.
So I went out and got a 64gb PNY class 10 SD card.
[The problem]
I loaded up all my games using the same folder structures as before,
but when I loaded up usb loader gx, I found that it would only read GC games from the SD card.
I then tried wiiFlow, as it's supposed to read from both, and it did, but when I try to load the games it just goes to a black screen
I then tired CFG loader mod, and It was also able to see the files, but it just refused to launch the wii games.
(gc games through nintendon't still load)
but it at least gave me an error message:
iso (249)
Iso reload: blocked
error: setting up fragments -2 3
ID mismatch [RSPE01] []
Error: SetWBFS: -3
I've googled the error, and tired (almost) all the suggestions
(obviously not the installing original wii cios stuff)
one person suggested turning 'block ISO load' to 'off'
Doing so give the same error, but without the 'Iso reload: blocked'
All the games are clean dumps that I've done myself and tested.
I even retested by coping the files from the sd card back to a flash drive,
and USB loader GX had no trouble launching them.
I even tried a suggestion of re-installing d2x cIOS
as shown here:
https://gbatemp.net/threads/simple-guide-to-install-cios-on-vwii-backup-nand-and-keys.339890/
but the problem still remains.
Any ideas?