so I'm going to have to leave the project stopped until a new updateWhen its good and ready. The guy is working on it in his free time. Asking won't make it happen any faster
I'm going to continue my c++ project
so I'm going to have to leave the project stopped until a new updateWhen its good and ready. The guy is working on it in his free time. Asking won't make it happen any faster
Atmosphere and Hekate, everything is in the pack, just to run the pack and choose the SD as destination.Thank you for answering me. But should I install Atmo and Hekate together or are they different?. Current console firmware is 16.01 ( recently updated)
I am also the subject because interestedHello everyone,
I have a question if any of you have tried to use IRHS8342 mosfet in Nintendo Switch Lite?
If so, could any of you please send what solder points I should solder to.
Because I don't understand from the pictures that are on the internet.
Thanks
lite has a Mariko boardHello everyone,
I have a question if any of you have tried to use IRHS8342 mosfet in Nintendo Switch Lite?
If so, could any of you please send what solder points I should solder to.
Because I don't understand from the pictures that are on the internet.
Thanks
look at the picture there u see the pins u need to solder it tooI know it's all there but I need to know exactly which pins on the mosfet to solder to.
Because when I soldered earlier it started burning the cable on the cpu
I don't know, I just soldered to the pins that were supposed to be usedSpójrz na zdjęcie tam u zobacz piny, które musisz też
Czy wyizolowałeś pin pod MOSFET?
what do u dont know?I don't know, I just soldered to the pins that were supposed to be used
Could you show me in a picture what to do?what do u dont know?
if u isolatet the pin that sits under the mosfet?
make sure the dot on the mosfet is on the buttom left when u solder it on
Could you show me in a picture what to do?
I don't want to make a mistake
lets also see a picture how u isolated the bottum padGive me a moment, I'll redo
okay pin out is right now u can solder it to the apu after u did that show another picture