I Accidentally injected the Hekate payload without SD Card and the switch screen stayed black. At first I didn't care but TegraRCMGUI said No RCM and My switch was un-responsive to anything i did.
What do I do?
What do I do?
well, i i KNOW my switch isn't patched. i injected the fusee-test.bin payload and it said that my switch is hackable. and i had already ran hekate 3 times before then. that's what confused me.if your Switch made a black screen when you injected the payload, it means it's not compatible with (software) hack and you need a modchip
i use a screwdriver to short pin 9 and 10 to enter RCM. anyways, i already rebooted the switch and it was just that something wrong when injecting the payload like Badablek saidIt looks like your method of entering RCM is faulty. How do you do it? Or do you use autoRCM? Anyway, you should turn off your Switch doing what's mentioned above. Then reboot normally, just to make sure everything is fine. Next, turn it off normally, and finally enter RCM with your jig. If you're using autoRCM, you'll get a black screen when you turn it on, so it's ready for payload injecting.
Make sure you install autoRCM before you screw up your pins with that screwdriver.i use a screwdriver to short pin 9 and 10 to enter RCM. anyways, i already rebooted the switch and it was just that something wrong when injecting the payload like Badablek said
i use a screwdriver to short pin 9 and 10 to enter RCM. anyways, i already rebooted the switch and it was just that something wrong when injecting the payload like Badablek said
Not interested! I don't need a jig. My joycon is modded. I know you quoted the wrong guy, just pulling your leg.Buddy, really buy a jig. That things are cheap as hell. Even to can buy a RCM loader and forget about damages and bad injections