how is gen 6 rng going to work with out a hacked 3ds thoughIt will eventually. The plan is to finish gen 7 first.
how is gen 6 rng going to work with out a hacked 3ds thoughIt will eventually. The plan is to finish gen 7 first.
how is gen 6 rng going to work with out a hacked 3ds though
If Gen6 Egg Seed RNG is very similar to Gen 7 Egg Seed RNG, You'd have to go through a tedious process of 128 softrests for every each of magikarp eggs to note their 1st and 2nd abilities in order to find your Egg Seeds.how is gen 6 rng going to work with out a hacked 3ds though
Well yeah the new Magikarp swap thing in sun and moon does not work on oras so its not the same means eggs are generated by main rngIf Gen6 Egg Seed RNG is very similar to Gen 7 Egg Seed RNG, You'd have to go through a tedious process of 128 softrests for every each of magikarp eggs to note their 1st and 2nd abilities in order to find your Egg Seeds.
There isn't a delay, because there are no NPCs. I had this problem with Lele, just persevere and it will happen. The more advanced the spread the harder it will be.I have followed the guides in this thread, but I am having difficulty hitting my frame when RNG Tapu Koko with a synchronizer. How do I find the correct delay? I have tried 3, 4 and 5 to no avail.
That's right, it may take a few attempts to hit it is all.Thank you. So I can just hit the exact frame and I'll be good to go?
Edit: Do I check the "Create Timeline" box?
what firmwareHi there, my issue is nothing shows up when I do the button combos.
I have installed CFW, BooTNTR, and PokeCalcNTR. I also use o3DS.
This is the root of my 3DS: https://imgur.com/a/gxJNI
This is my 3DS home menu: https://imgur.com/a/oq7r4
I do the following steps: open BooTNTR Mode 3, wait for "NTR CFW loaded successfully," press HOME to return to main menu, load Pokemon Moon. But I cannot do any button combos.
Also, does this have anything to do with Enable Debugger? I can only press X+Y right after pressing HOME to return to main menu, but I get this message when I press A to Enable Debugger: "svc_controlMemory failed: c860180a, Press B to close." Nothing shows up when I press X+Y after waiting for the home menu to fully load.
Thanks!
My 3DS is 11.3. I installed everything according to 3ds.guide.what firmware
How should I time the Rotom blinks?That's right, it may take a few attempts to hit it is all.
You don't need the timeline feature because there are no NPC movements to compensate for. All you need to worry about is Rotom blinking, which causes the frame increments to freeze for a brief moment.
You can't control it, and it doesn't disrupt the frame advancements. Just an extra element to be aware of that's all. If you pause and find the frame doesn't advance, chances are you paused mid blink. Just keep pressing select until you advance past the blinking cycle and it should go back to increments of 1.How should I time the Rotom blinks?
Try using BootNTR selector (w/ mode 3). Compatibility with new OFW versions (including 11.4) seems to be possible much sooner.My 3DS is 11.3. I installed everything according to 3ds.guide.
Aww okay, I understand. These good HP spreads are hard to come by with low frames.You can't control it, and it doesn't disrupt the frame advancements. Just an extra element to be aware of that's all. If you pause and find the frame doesn't advance, chances are you paused mid blink. Just keep pressing select until you advance past the blinking cycle and it should go back to increments of 1.
Yes. As I say the more advanced the spread the harder it is to come by. Especially with Tapus. At least in my experience.Aww okay, I understand. These good HP spreads are hard to come by with low frames.
You need to press A On you bag once you've hit your frame. If you aren't hitting it then the frame is incorrect in the tool. Make sure the correction for Nihilego is set to 19 rather than the default 13.For the UBs, do I use the honey right after I hit my frame? Also, synchs can still be fainted, right? I'm getting the wrong IVs when I encounter Nihilego.
Thank you. I beat the last trainer in the cave and was able to get the Nihilego. I'm about to get my first Pheromosa with Modest HP Ground.You need to press A On you bag once you've hit your frame. If you aren't hitting it then the frame is incorrect in the tool. Make sure the correction for Nihilego is set to 19 rather than the default 13.
Synchs can be fainted but must be in the lead slot in your party to work.