Well im out of the game my XL CMD point has come off the board though never really used Roms was more just interested in tech. *removed*
Well im out of the game my XL CMD point has come off the board though never really used Roms was more just interested in tech. *removed*
Update: managed to remove some of the glue on NAND and have found trace to CMD pad so with extremely fine wire i should be able to write 4.4 back on unit.
beware everyone try not make same mistake as me. this CMD point is beyond repair as trace is only just visible might see if i can buy another 3dsxl @ 4.4
beware everyone try not make same mistake as me. this CMD point is beyond repair as trace is only just visible might see if i can buy another 3dsxl @ 4.4
When you say its only just visible isn't that enough ? you should be able to so connect to that
Yeah I will attempt to repair again however where the trace is to CMD the copper is showing left and right of that. It's extremely hard to get solder on only the finest fine trace without bridging. That's with flux aswell. It's just easier for me to pick up another 3dsxl and not waste anymore time on this one
Ive concluded that modding a port to make dumping more comfortable is not necessary.
Considering that it takes about 10 Minutes to open the case, connect the 4 points and start dumping ruining the case is not worth it ^^
The trace does not seem that small
Trust me its small these photos are all blown up. I have made SNES Repro Carts and soldered a infectus v2 chip on 360 nand when JTAG first started. I just can't be bothered any more plus i do agree with adding ports (micro usb etc)
Soldering to those point over and over will weaken them so i do believe in adding a Microusb or similar. I did this mainly because i was swapping between my 6.3fw with all eshop purchases & 4.4 for gateway. I'm not sure emunand would help me as i already have my 6.3 dump with purchases info. Emunad looks like you upgrade via Nintendo which would mean for me i would lose all my eshop games. so this mod was a must so i could easily swap between Firmwares