Hacking won't fit into slot 2

[jackb]

ok so my EZ 3 in 1 came today and it doesn't fit into the slot 2. i think it is being caused by the connector board (main board) sticking out and preventing it from going in properly. has this happened to anyone else and if so what did you do...

thanks in advance

 

[.::5pYd3r::.]

You have to put the EZ flash 3 in 1 in the the slot on a bit of a slant so the connector board points toward the upper screen

 

[zombielove]

Yup. It happened to me. I just tried at a different angle. These days it seems to go in fine no matter what angle it's on.

 

[jackb]

thanks you very much i was really getting pissed off lol... so you say that it will fix itself over time..?

 

[sasuke_kun12]

i always put the 3in1 with my nds laying flat so that the 3in1's pcb is laying flat against the case when i slot it in