won't fit into slot 2

Discussion in 'EZ-Flash' started by jackb, Sep 19, 2007.

Sep 19, 2007

won't fit into slot 2 by jackb at 6:59 AM (736 Views / 0 Likes) 4 replies

  1. jackb
    OP

    Newcomer jackb Member

    Joined:
    Sep 8, 2007
    Messages:
    26
    Country:
    Antarctica
    ok so my EZ 3 in 1 came today and it doesn't fit into the slot 2. i think it is being caused by the connector board (main board) sticking out and preventing it from going in properly. has this happened to anyone else and if so what did you do...

    thanks in advance
     
  2. .::5pYd3r::.

    Member .::5pYd3r::. Viva La Pizza

    Joined:
    Jun 2, 2007
    Messages:
    766
    Location:
    The GREAT Southern Land :D
    Country:
    Australia
    You have to put the EZ flash 3 in 1 in the the slot on a bit of a slant so the connector board points toward the upper screen
     
  3. zombielove

    Member zombielove GBAtemp Regular

    Joined:
    Jun 3, 2007
    Messages:
    270
    Country:
    Australia
    Yup. It happened to me. I just tried at a different angle. These days it seems to go in fine no matter what angle it's on.
     
  4. jackb
    OP

    Newcomer jackb Member

    Joined:
    Sep 8, 2007
    Messages:
    26
    Country:
    Antarctica
    thanks you very much i was really getting pissed off lol... so you say that it will fix itself over time..?
     
  5. sasuke_kun12

    Member sasuke_kun12 GBAtemp Regular

    Joined:
    Aug 12, 2007
    Messages:
    202
    Location:
    Tokyo 3
    Country:
    Australia
    i always put the 3in1 with my nds laying flat so that the 3in1's pcb is laying flat against the case when i slot it in
     

Share This Page