- Joined
- Oct 7, 2007
- Messages
- 4,478
- Trophies
- 3
- Age
- 36
- Location
- Levelland, Texas
- Website
- www.mariopc.co.nr
- XP
- 6,937
- Country
Which DAT line is it? If you aren't using the others I believe you have to use DAT0. Not DAT1 etc.
It's dat0...Which DAT line is it? If you aren't using the others I believe you have to use DAT0. Not DAT1 etc.
Did you use dat0?Ok I did the hardmod with 1 dat wire only. The hardmod doesn't work, the blue screen doesn't show up... I have a multimeter, can I use it to check if the mod is fine or if I have to resolder?
Yeah I used dat0. As gnd point I used the one shown in the first page (n3ds xl)... Maybe wires are a little bit long, about 15cm each... The multimeter gives me a value for every point (dat0, cmd and clk), although clk has really really low voltage...Did you use dat0?
You can use a multimeter to check, you can also just visually check your points. How long are your wires? What did you use as a Gnd point?
Yeah I used dat0. As gnd point I used the one shown in the first page (n3ds xl)... Maybe wires are a little bit long, about 15cm each... The multimeter gives me a value for every point (dat0, cmd and clk), although clk has really really low voltage...
But I already redid it and I still get the same value...redo clk then. voltage really matters and it being low will probably mess up any kind of communication with the NAND.
But I already redid it and I still get the same value...
But I already redid it and I still get the same value...
But I already redid it and I still get the same value...
But I already redid it and I still get the same value...
My wires are not extremely small but definitely not bigwhat gauge wire are are using then?
But shouldn't it show a bluescreen, even if the card reader is not compatiblethat's a known problem , you need one of those sd card readers noted in the first post
lucky you are in italy and can order one from amazon ..sadly i can't order because amazon doesn't send to my country
Yes it should. That's what mine did, I'm still trying to figure out what is wrong on mine. Got a similar issue - computer won't see it as a driveBut shouldn't it show a bluescreen, even if the card reader is not compatible?
The problem is that I can't get it again!well , the blue screen is there , what do you want to see more?
aaah , if you mean the top screen , then the N3ds doesn't show anything on top screen
also when you get that screen , you can unplug the sd card adapter , then plug it again(if asks you to format , don't agree , you will erase your nand XD )