1. ignudi

    OP ignudi Newbie
    Newcomer

    Joined:
    Jun 30, 2020
    Messages:
    8
    Country:
    Philippines
    i have an unpatched switch with stock 4.1.0 FW. i created an emuNAND on a microsd card and used hekate/atmosphere to install 8.1.1 CFW on it. i eventually updated the CFW to 10.0.0.

    after the update, the switch constantly nags me to update the joy con controllers. once i mistakenly selected 'Update', but i immediately detached the joy cons before the update could complete.

    now, the joy cons only work when attached to the switch. is this somehow connected to my refusal to update the joy con controllers? i'm afraid that if i update the joy con firmware, the joy cons might not work if i boot to stock 4.1.0 FW. now, even on 4.1.0, i'm always nagged to update the joy cons.

    is it ok to accept the update? am i missing anything with not updating? will the updated joy cons work on 4.1.0? and will i never be able to use the joy cons wirelessly until i accept the update?

    by the way, the right joy con controller is unmodded.

    thank you guys.
     
    Last edited by ignudi, Jul 21, 2020
  2. abk14459

    abk14459 Advanced Member
    Newcomer

    Joined:
    Aug 1, 2016
    Messages:
    71
    Country:
    United States
    Update is fine. Won’t do anything to your stock version
     
  3. ignudi

    OP ignudi Newbie
    Newcomer

    Joined:
    Jun 30, 2020
    Messages:
    8
    Country:
    Philippines
    thank you for the reply!
     
Draft saved Draft deleted
Loading...

Hide similar threads Similar threads with keywords - detached, connect, Switch