WiiFree - JDM help

Discussion in 'Wii - Hacking' started by cracker, Jan 1, 2008.

  1. cracker
    OP

    cracker Nyah!

    Member
    6
    Aug 24, 2005
    United States
    I just got a JDM programmer and some chips from microchip.com and have run into a problem. I have tried both 12f629 and 12f275. They can be read fine but when it comes to writing I will get an error from IC-Prog telling me that programming failed at 0000h. Oddly enough the first two bytes are actually written fine to the chips despite what the error says. I have tried the programmer on other computers and get the same result (except from the laptop which barely had enough power from the serial port to light the green LED). I have tried altering settings to no avail. Hopefully someone can help me figure out what is going on here...

    Here's the manual for it.
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice