I'm not complaining, It's just a spare 3DS XL that I have but I'll post it anyway. I was trying to a9lh the said console, I'm almost done, I'm at the part where I have to downgrade the REDNAND to 2.1(Not yet on the "One Click Setup mind you). Everything was fine, I booted up REDNAND with no issues at all, run PlaiSysUpdater and pressed X to downgrade to 2.1. It went pass HAX INIT and then a couple of hash checks passed, and then a couple of minutes I saw it got stucked on 1 cia. I waited for like, 5 minutes and it's not even responding, still stucked. So, knowing that it's REDNAND, I figure it's perfectly fine to hard reboot it since I can just rerun Emunand9 on sysnand and flash the working emunand back. But boom, nothing is working afterwards. Menuhax not booting, sysnand not booting(although sometimes it does, but it hangs and Nintendo error afterwards.
I might have to add that the console's SD card slot was not working before, I tried to fix the pins(because it was not aligned properly) and it brought back the sd card slot to life.
Do you think hard modding it and flashing back the back up sysnand will still works? I have no clue on soldering but heck, it's already brick so why not? And also, unfortunately, It accidentally slide when I was removing the back cover, hence, the left shoulder buttons ribbon cable got ripped off, talk about lucky.
I might have to add that the console's SD card slot was not working before, I tried to fix the pins(because it was not aligned properly) and it brought back the sd card slot to life.
Do you think hard modding it and flashing back the back up sysnand will still works? I have no clue on soldering but heck, it's already brick so why not? And also, unfortunately, It accidentally slide when I was removing the back cover, hence, the left shoulder buttons ribbon cable got ripped off, talk about lucky.