Well my sd reader out of no where decided to smoke,
Changed it with another and booted once, then continous blue screen, left it for 30 mins then it turns on but doesnt get pass the logo
Removed it and still the same, i removing the qsb in an hour and revert everything back to normal and will try tommorow using better tools, but whats your take on this
appologizes for the quality its by my phone zoomed till it cracked
what else can i check like caps around the sd card or what, i have a doner board so i can pretty much take what i want from it
--------------------- MERGED ---------------------------
I belive i found a cap shorting from where the nand sits, in my doner its not shorting while on this it is.
Thats a start
i marked it
--------------------- MERGED ---------------------------
Now its back to blue screen again
I have to desolder the sp1 and 2 and see how it goes, but any ideas would be helpfull as well