I have a phat ps3 60gb backwards compatible and had a non working blu-ray drive so i had to install a cfw no-bd because regular cfw wont load apps and stuff just goes to blank screen. like title says i did the remarry process dumped the eid key and remarry process in factory service mode and it said success, but when i put a ps3, ps2 disk the drive does the same of nothing just like before remarry process. It does receive disks and ejects them just i don't even hear the laser trying to read its just dead silence.
btw now that it got remarried and now with a regular cfw apps and stuff open up without blank screen issues.
Now i do have another ps3 drive maybe 2 of them from another ps3 think its from a 40gb ps3, only difference physically it doesn't have that outside daughter board circuit board attached to the bottom of the drive, I don't know if the newer ps3 drives have the daughter-boards built in and not exposed maybe someone knows here but can i use that one and remarry it? If i cant what you think i need for the current one like what part either the drive physically/mechanically is bad or is the daughter board bad of not allowing the laser to not even try to read disks and make noises etc? thanks
btw now that it got remarried and now with a regular cfw apps and stuff open up without blank screen issues.
Now i do have another ps3 drive maybe 2 of them from another ps3 think its from a 40gb ps3, only difference physically it doesn't have that outside daughter board circuit board attached to the bottom of the drive, I don't know if the newer ps3 drives have the daughter-boards built in and not exposed maybe someone knows here but can i use that one and remarry it? If i cant what you think i need for the current one like what part either the drive physically/mechanically is bad or is the daughter board bad of not allowing the laser to not even try to read disks and make noises etc? thanks