In that case, you have little to lose by just setting up a9lh since either way you need to start again. Follow https://github.com/Plailect/Guide/wiki or go to quantumc.at (can download the whole guide and all files). Either way start on part 1 (Decrypt9).hmmm, I actually enter into RXtools using the internet browser method, none of the three methods work, Ill read more into it, thanks.
You came at a good time, the Plailect guide just got a big makeover and now takes about 40min instead of 4 hours :-)thank you, guess I will have to start all over![]()
You'll only have a problem if:But there is still no failsafe when you don't have a hardmod, right?
She's*he's right , a9lh + luma is the best way to go and right now it's easier than ever (:
If you get stuck at any step , users around here will be fast to help.
You'll only have a problem if:
a) During the downgrade to 9.2, you use the files for the wrong region or console (no problem for you, you won't be downgrading). All other writes are 100% safe, because the tools check that the files are correct before proceeding
b) Your SD card craps out while writing to the NAND (the chances of your SD card failing right at that moment are pretty slim), or your battery falls out during the same (don't do it while the back cover is off and you're holding it in the air without a finger under the battery).
All other circumstances, the tools make sure you can't make a mistake, so you don't have to worry. And if any steps don't make sense or seem ambiguous, we're all here to answer your q's.
If you do really want to worry though you can do a simple menuhax installation like I said above :-)
If you follow the guide exactly as it's shown, your console specific otp.bin will be in the /a9lh/ folder after actually installing arm9loaderhax.thanks for the reply. but what about that "OTP getting" and forgetting to turn ON WiFi-brick?
You don't actually need the otp.bin during the install process (but it's nice to have). If you forget to turn on the wifi before going to 2.1, you just have to take out the battery for a minute then put it back in, and that resets wifi to be on.thanks for the reply. but what about that "OTP getting" and forgetting to turn ON WiFi-brick?
oops ( ͡° ͜ʖ ͡°)She's*![]()