Run M3 Sakura 1.4x on Supercard DSTWO

Discussion in 'M3 Adapter' started by Jaylen, Feb 26, 2012.

Feb 26, 2012
  1. Jaylen
    OP

    Newcomer Jaylen Member

    Joined:
    Mar 14, 2009
    Messages:
    41
    Location:
    Michigan, USA
    Country:
    United States
    Hello, I want to know how to do it because I know it is possible with the lower 1.12 version.
    Sure I know I could patch moonshell 2 to run Rom's but to be honest it is just not the same. I can't slide thing's left and right

    The one bad thing about the DSTWO and basically every other card is that you cannot do everything all in one firmware and that is the one thing I miss.

    Just asking for insight on how this could be achieved...also how to run AKAIO or any other firmwares from the DSTWO would be nice too...
     
  2. Crystal the Glaceon

    Member Crystal the Glaceon GBAtemp Inkling™ Squishies~

    Joined:
    Sep 13, 2009
    Messages:
    14,741
    Location:
    Inkopolis
    Country:
    Antarctica
    Why would you do that?
    Seriously the Supercard DSTwo is leaps and bounds ahead of Sakura, all Sakura has going for it is it looks nice.
    As well there is a Wood R4 plugin, homebrew soft-reset doesn't work that well though (and honestly I don't even know if it works anymore to begin with.) But it is impossible to run any other Kernal on the DSTwo, if you want AKAIO or any other kernal out there, buy the card, they aren't very expensive anymore.
     

Share This Page