2 ways.How do we skip verification?
There are certain reasons I never supported SDSC, aka 1bit bus, and this is one of them.Hi @CTCaer
I am experiencing a weird issue with my SD card reader.
Since it was acting up (loose spring) I finally decided to change it altogether.
I used a non official one and only Horizon could detect (neither hekate nor ReiNX could in rcm).
Then I replaced it with an official one and funny enough the same issue remains.
I can perfectly use in in Horizon but the payloads don't detect it at all.
Is it possible that some pins were bent or broken during the replacement process that is causing this?
Is it possible to launch CFW from the payload alone? If possible could you help me out with such a customized payload?
Thanks in advance
This power on triggers in 15s after powering off from HOS. If you power off inside that time you are good to go and Auto HOS power off does not even get the change to be procced.How does Auto HOS power off work? If I enable it and boot SX OS, when I turn my switch off, do I have to wait 15 sec for it to boot into RCM and then it will turn it off? The only time I turn it off is to remove SD card and I don't want to remove it while it's rebooting.
You need to combine it into 1 file through the scripts I have at github. Then use an exFAT sdcard and copy it to /backup/<eMMC S/N>/restore.Dear sirs!
I backuped my switch long ago, actually a don`t know what vershion of Hecate it was. Now i want to restore my switch but on current version the restore process doesnt restore anything. I have 16 files named RawNand.bin.00- 14 (29,1Gb). I have tryed both fat3 and fat32ext on my flashcard - no luck. Please-please-please help me! How can i restore my switch to the ?
Hekate is just a bootloader. It primarily loads Atmosphere. The "sig patches" Atmosphere uses do not work on 6.1 and need to be updated. However, the smart patching ReiNX implemented do work on 6.1.Anyone having issues with Hekate not loading games after 6.1 update? Have a 256gb card filled and 99% of all my games are erroring out on launch. Re-installing them gives same results.
Hekate is just a bootloader. It primarily loads Atmosphere. The "sig patches" Atmosphere uses do not work on 6.1 and need to be updated. However, the smart patching ReiNX implemented do work on 6.1.
Try to squeeze plastic where under is the connector and try again. You can see some crystal clear cases to find where to push.
If that works, you need to check the connection and if you didn't replace the padding on top of it, add it back.
And maybe add a little extra.
Not plastic. Something flexible is preferred. So it can put adequate pressure and also not bulge the spot.Thanks for the reply.
I am in the process of doing this now. Just to be sure: do you mean putting plastic between the SD card reader connector and that of the motherboard?
Not plastic. Something flexible is preferred. So it can put adequate pressure and also not bulge the spot.
^^It works! Just like you said!
Thank you so much!
Thanks!! So I guess once I have my Switchme installed, the best way to go is boot into Hekate that auto boot SX OS while having Auto HOS power off enabled. That way when I power off it will reboot in hekate and hekate will power off right?This power on triggers in 15s after powering off from HOS. If you power off inside that time you are good to go and Auto HOS power off does not even get the change to be procced.
Also if you don't launch hekate, it will also not power off.
Correct.Thanks!! So I guess once I have my Switchme installed, the best way to go is boot into Hekate that auto boot SX OS while having Auto HOS power off enabled. That way when I power off it will reboot in hekate and hekate will power off right?