this is my first post about my switch oled problem
after i remove pico
i got nintendo logo and switch logo, but never get into menu
restart switch and get black screen
i realize my dat0 adapter suck so i change the good one
and i got succes led light
i know glitch work by see led light
So if we analyze the flows like this:
"when i press the power on
Picofly logo show normaly, when i press volume -+ to get OFW, just show blackscreen"
At this point i suspect the partition corrupted, need to rebuild.
"I unplug battery and plug in back, i got error ** (RST)"
The RST line is not stable.
"I change RST cable and now got =**"
RST line stable, Emmc init worked, but failed in the glitch stage.
I suspect the Dat0 is 'lightly' touch the Dat1, so the emmc its not stable.
"Picofly logo show again and cannot get into OFW
Just blakscreen again"
When the glitch work, the initial problem occured, which is partition corrupted.
"So i add more resistor cause i think toshiba need more resistor (47+47)
And now got =***"
At this point, the initialization of emmc is not even detected, after reset, before glitch.
Could be problem with combination of CLK, CMD, or Dat0.
"this is my first post about my switch oled problem
after i remove pico
i got nintendo logo and switch logo, but never get into menu"
The emmc hardware still okay, but the same problem still not fixed, which is the nand partition corrupted.
"i realize my dat0 adapter suck so i change the good one
and i got succes led light"
If the glitched worked, the picofly should shows.
In current firmware.
The success light pulse should be * (1 short light). (Repeat 3 times as usual).
There is no information about this on Led Indication, i read it from the code.
If the ram still okay, then without the pico, the nintendo logo still shows up, then blackscreen. Means the partition still corrupted. But if the ram failed, i think there will be no nintendo logo shows up.