I hope someone can help me...
I modded my Oled Switch (3 months ago) with INSTINCT NX V6 and it was working fine... as I was playing it froze and gave me an atmosphere error screen... I turned it off and after that, I had a black screen….
After some attempts, it finally booted to Heakte and I restored the EMMC successfully, tested and seemed okay without errors...
I installed some games and as I was playing Mario Kart and again after 2 hours atmosphere error screen.
Since then the switch has been on a black screen and the chip is blinking white…
(When connected to computer it recognises as Nintendo Switch APX Device...)
I am sure that the emmc again is corrupted.
Is there any way to restore it with INSTINCT NX? (I have read that with HWFly modchip you can use Hwfly nx firmware which allows for glitching into an empty Nand so you can load heakte and restore the backup...)
What else can I do to restore it? Only remove it and restore it with programmer? (which I don't have )
I am sure that the chip is installed correctly... at first, it was installed with wires, I had tested all the points, and were okay...
Just for testing, I removed it and tried to boot the switch without the modchip, and again black screen..
Now I have installed it with the flex cable and not enameled wires...(I don't like it... think I will remove it and use the enameled wires again)...
I have tested all the points with a multimeter and everything seems ok...
What else should I have to check? I am stuck now...
Later i will try with putty to see the chip status..
Any suggestions are welcome
I modded my Oled Switch (3 months ago) with INSTINCT NX V6 and it was working fine... as I was playing it froze and gave me an atmosphere error screen... I turned it off and after that, I had a black screen….
After some attempts, it finally booted to Heakte and I restored the EMMC successfully, tested and seemed okay without errors...
I installed some games and as I was playing Mario Kart and again after 2 hours atmosphere error screen.
Since then the switch has been on a black screen and the chip is blinking white…
(When connected to computer it recognises as Nintendo Switch APX Device...)
I am sure that the emmc again is corrupted.
Is there any way to restore it with INSTINCT NX? (I have read that with HWFly modchip you can use Hwfly nx firmware which allows for glitching into an empty Nand so you can load heakte and restore the backup...)
What else can I do to restore it? Only remove it and restore it with programmer? (which I don't have )
I am sure that the chip is installed correctly... at first, it was installed with wires, I had tested all the points, and were okay...
Just for testing, I removed it and tried to boot the switch without the modchip, and again black screen..
Now I have installed it with the flex cable and not enameled wires...(I don't like it... think I will remove it and use the enameled wires again)...
I have tested all the points with a multimeter and everything seems ok...
What else should I have to check? I am stuck now...
Later i will try with putty to see the chip status..
Any suggestions are welcome
Attachments
Last edited by Ferz1984,