Hold Select and tick Autoboot emuNAND in the config menu, then Start to restart.Section II - Installing boot9strap
Reboot holding (Start) during boot to launch the Luma3DS chainloader menu
Launch SafeB9SInstaller by pressing (A)
Wait for all safety checks to complete
When prompted, input the key combo given to install boot9strap
Once it has completed, press (A) to reboot your device.
it will only boot to System 9.2.0-20U
What am I doing wrong?
Which part is it loading your sysNAND 9.2 unexpectedly? After the boot9strap installation completes, or when you try to reboot holding Start?Section II - Installing boot9strap
Reboot holding (Start) during boot to launch the Luma3DS chainloader menu
Launch SafeB9SInstaller by pressing (A)
Wait for all safety checks to complete
When prompted, input the key combo given to install boot9strap
Once it has completed, press (A) to reboot your device.
it will only boot to System 9.2.0-20U
What am I doing wrong?
Are you booting into sysNAND 9.2 when you try to boot SafeB9SInstaller, or are you booting into sysNAND 9.2 after you use SafeB9SInstaller to update B9S? Your post wasn't entirely clear.this is what I see
--------------------- MERGED ---------------------------
when you try to reboot holding Start?
If SafeB9SInstaller won't even boot, then it sounds like you don't have B9S installed at all. Have you installed B9S using SafeB9SInstaller before?when you try to boot SafeB9SInstaller
--------------------- MERGED ---------------------------
i an trying to update bs9
Did you put SafeB9SInstaller.firm into the payloads folder in the luma folder on your SD card? Are you holding Start and not Select?yes
--------------------- MERGED ---------------------------
this is what i see
If you cannot follow this guide properly, then you shouldn't be doing any of this, and you should stay on Luma3DS 7.1 indefinitely. If you don't follow instructions, you could accidentally brick your 3DS.i am missing the SafeB9SInstaller.firm
--------------------- MERGED ---------------------------
do i copy the new version?
If you're missing SafeB9SInstaller.firm on your SD card, then you didn't follow the guide properly.i am follow this guide properly I hold start and power boot to 9.2
i have it in the folder still no luck