Hi guys, as written in the title, I got a switch which gives the error "Could not start the software" after booting (both logos) when launching both CFW and FW. It has 15 burnt fuses but if I read the eMMC using NxNandManager the FW version is 6.1.0.
I have tried to update to 12.0.2 or even 10.0.4 using EmmcHaccGen following this (up to step 12) and this guide but, when I read again using NxNandManager, the version is still 6.1.0. Why doesn't NxNandManager show the new version? I have tried using Android 10 and the console works perfectly, so I am assuming there is an issue with the eMMC. Is it the right procedure to perform the update? Has anyone faced this issue before?
I have tried to update to 12.0.2 or even 10.0.4 using EmmcHaccGen following this (up to step 12) and this guide but, when I read again using NxNandManager, the version is still 6.1.0. Why doesn't NxNandManager show the new version? I have tried using Android 10 and the console works perfectly, so I am assuming there is an issue with the eMMC. Is it the right procedure to perform the update? Has anyone faced this issue before?