I recently found out about freeshopNX and decide to give it a go, I tried a tin foil rcm jig and I had my switch plugged into my PC. I held the buttons to get into RCM Mode but nothing came up on the console and nothing changed on the application on my PC it could not detect the RCM. I took both joycons out and disconnected it from my PC. Still no life, I pressed the power button a few more times to no avail. I began to have a panic attack becuase I thought I fried my switch (this would not be the first electronic device I have fried I did from my old laptop previously) I left it alone for a few seconds then tried again. Never in my life have I been so happy to see a Nintendo logo. I fell on the floor with relief. But i always was curious about what I did wrong. I did not seem to find any documentation on people having problems with jigs. What to do you all think?