Atmosphere Black screen after installing FW 18.1.0 on OLED

[Lucasalv90]

Hi to all.
I have a Switch OLED with modchip, and was on FW 17.0 but wanted to update to 18.1.0

So as usual I downloaded the latest atmosphere/fussee.bin/hekate/signpatcges from usual sources and put it in the SD card. Then atmosphere loaded correctly and I went on homebrew menu to update the firmware to 18.1.0 with Daybreak.

After the update I clicked reboot, it booted to Hekate menu and I choose as usual the payload fussee.bin, but now i get a black screen after the Atmosphere logo.

I do not understand what I did wrong, as I usually updated this way.
Is there something (maybe some other homebrew) that causes this crash because not compatible to newer firmware?
Can somebody help me with a solution?

Thank you very much in advance!

 

[thesjaakspoiler]

Ran into this issue several times and in all cases just removing the Atmosphere/Hekate folders and installing a fresh install fixed the issue.
Also make sure that you use the fusee.bin that comes with the latest install and mind that an older version might be loaded off your SD card.
Homebrew should in most cases not have any effect on booting Atmosphere, unless it's one of those system module hacks.
If you suspect it is one of those, just install a normal install first and then start adding such modules/.

 

[Lucasalv90]

Ran into this issue several times and in all cases just removing the Atmosphere/Hekate folders and installing a fresh install fixed the issue.
Also make sure that you use the fusee.bin that comes with the latest install and mind that an older version might be loaded off your SD card.
Homebrew should in most cases not have any effect on booting Atmosphere, unless it's one of those system module hacks.
If you suspect it is one of those, just install a normal install first and then start adding such modules/.

Thank you for the reply.
I actually tried that way but after I did my switch booted into Official Firmware directly.
Maybe is because my switch uses modchip and needs some other files inside those folders (just by guess). I don't know which files though, except the boot files in the root of SD

 

[Hayato213]

Hi to all.
I have a Switch OLED with modchip, and was on FW 17.0 but wanted to update to 18.1.0

So as usual I downloaded the latest atmosphere/fussee.bin/hekate/signpatcges from usual sources and put it in the SD card. Then atmosphere loaded correctly and I went on homebrew menu to update the firmware to 18.1.0 with Daybreak.

After the update I clicked reboot, it booted to Hekate menu and I choose as usual the payload fussee.bin, but now i get a black screen after the Atmosphere logo.

I do not understand what I did wrong, as I usually updated this way.
Is there something (maybe some other homebrew) that causes this crash because not compatible to newer firmware?
Can somebody help me with a solution?

Thank you very much in advance!

something incompatible would give you an Atmosphere crash screen not black screen. Where you source your firmware?

 

[Lucasalv90]

something incompatible would give you an Atmosphere crash screen not black screen. Where you source your firmware?

I downloaded it from the website called Darthsternie

 

[Hayato213]

I downloaded it from the website called Darthsternie

It is the same source I use. You have any nand backup? You tried replacing the cfw files with the latest and it doesn't work?