Any way to "upgrade" an EZ Flash IV carts housing/shell

Discussion in 'GBA - Flashing Hardware and Software' started by IngrownTesticle, Jun 4, 2012.

  1. IngrownTesticle
    OP

    Newcomer IngrownTesticle Member

    Joined:
    Jun 2, 2012
    Messages:
    17
    Country:
    United States
    It seems common knowledge that the EZ Flash IV full sized cart are not the most sturdily build flashcarts. Has anyone had any success replacing or upgrading the housing of shell of the EZ Flash IV full sized flashcart?

    I mean anyone that has replaced a battery is going to have a janky EZ Flash IV.
     
  2. Catastrophic

    Member Catastrophic Perfectly Normal

    Joined:
    Apr 28, 2012
    Messages:
    654
    Location:
    Somewhere
    Country:
    Iceland
    I think the built quality of the IV is fine. It's pretty much inevitable that the cart will be janky unless you're skilled at soldering and don't use any tape methods as the actual hardware fits into the shell pretty much perfectly.
     
  3. IngrownTesticle
    OP

    Newcomer IngrownTesticle Member

    Joined:
    Jun 2, 2012
    Messages:
    17
    Country:
    United States
    my ez flash iv was glued below the the mini sd card slot. looks shoddy and i just got it.
     

Share This Page