Thank you for reply!! I contact with this seller. Waiting response
That looks pretty useful, over my head, but useful.
oHi,
I'm trying to perform the same mod for 32 pin GBA.
Is this ribbon cable the correct one to buy?
http://www.ebay.co.uk/itm/371348368059?_trksid=p2060353.m1438.l2649&ssPageName=STRK:MEBIDX:IT
The seller you mentioned doesn't have any listed any more
Also was wondering what size resistor to use?
But I have two questions to continue:
1. Wich is the correct point in C56 for the soldering the red whire, the pad 1 or 2? and why is it necessary to solder this cable?
2. I can't close the full shell, apparently one condensor is very big and the screen AGS 001 too
How you can close the case correctly?
Thank you!!
No, that is my GBA and it is original :S I this pic you can see better
Hi guys
Nice to finally find a place, concentrating on the AGS-001 screens, especially as I'm having some problems making my setup work, so this seemed like the obvious place to ask for help.
I got a frontlit ribbon from Lee_chan1985, as per Nusdogg's suggestion (without the P1 spot)
The screen is lit if I only connect the ribbon, but the trouble starts when I solder the red cable to either the spot below R12 or the top spot by C56.
When the red cable is soldered and I turn on the the AGB, only the power led turns on, the screen is completely off and there is no "boot" sound.
I've tried messing with the small "dial" shown in this video at 1:10, with no result:
Any suggestions as to what I could try next, would be deeply appreciated
Hi guys! I've checked throught this topic, but I have a question...I have an unused backlit cable and a frontlit screen & you said it does not work (I tried )...before buying the frontlit cable, I would like to try something...what are the differences between the two cables? Do you think it is possible to mod the backlit one?
So, if I find a resistor and solder it to the backlit cable, theoretically I should get the same result as a frontlit one, right?
(btw that's a wonderful collection)