Hardware Switch OLED waterdamaged, no (touch)screen

Rustbucket · 2024-11-24T19:00:26+0000

I bought a non functioning Switch OLED. At first it didn't start up, after giving it a good clean with alcohol it works, except for the screen and touchscreen. It does work perfectly in the dock, but the internal screen and touchscreen don't give any sign of life.

My guess it is either the voltage to the screen module since on the OLED version the touchscreen is integrated, but I am not sure..

How/ where can I measure if there is voltage going to the screen and what should the voltage be?

jkyoho · 2024-11-24T19:03:49+0000

measure the LCD connector diode reading first

The Real Jdbye · 2024-11-24T19:16:22+0000

Rustbucket said:
I bought a non functioning Switch OLED. At first it didn't start up, after giving it a good clean with alcohol it works, except for the screen and touchscreen. It does work perfectly in the dock, but the internal screen and touchscreen don't give any sign of life.

My guess it is either the voltage to the screen module since on the OLED version the touchscreen is integrated, but I am not sure..

How/ where can I measure if there is voltage going to the screen and what should the voltage be?

Have you cleaned the ribbon cables and connectors too? Connectors can be tough to clean if they have corrosion.

Rustbucket · 2024-11-24T20:00:57+0000

The Real Jdbye said:
Have you cleaned the ribbon cables and connectors too? Connectors can be tough to clean if they have corrosion.

Yes the ribbon cables and connectors have been cleaned and I can't see any (more) corrosion with my microscope.

Post automatically merged: Today at 8:02 PM

jkyoho said:
measure the LCD connector diode reading first

I kind of understand the image but not completely. Should I measure every pin with ground to get the same values as present in your image?

randy_w · 2024-11-24T20:50:19+0000

Rustbucket said:
Yes the ribbon cables and connectors have been cleaned and I can't see any (more) corrosion with my microscope.

Post automatically merged: Today at 8:02 PM

I kind of understand the image but not completely. Should I measure every pin with ground to get the same values as present in your image?

Black on ground and probe every single pad with red probe in diode mode, should have same readings as the picture. If not then trace the signal with motherboard layer diagrams till you find the problem.

Btw if you have another working motherboard test the screen assembly first, could be some water got inside the screen and damaged it. Once spent 2 hours tracing every signal and replacing the FPC connector, till realizing the previous owner somehow poked a small hole on the ribbon cable with tweezers.

jkyoho · 2024-11-24T21:32:09+0000

diode mode reading is red prob on ground in most case.
The values may be different in small range like 0.50--0.100v is normal

Hardware Switch OLED waterdamaged, no (touch)screen

New Member

Well-Known Member

Attachments

*is birb*

New Member

Well-Known Member

Well-Known Member

Similar threads

Popular threads in this forum

is birb