I didn't see anything about formatting?
my emunand is a full rawnand so i can't do the steps where you merge full.00-full.03
This part
"I then opened the newly created full.bin using hacdiskmount and double-clicked on the USER partition.
At the bottom of the previous screen, the log showed that the secondary GPT had an offset error.
I input the two parts of BIS Key 3 (I obtained them using biskeydump v7) and clicked to test them. The verification failed.
I mounted the USER partition anyway after installing the Virtual Drive driver.
I then used
this tool to retrieve my game saves and unpack them :
I copied all the folders located in the "save" folder of the newly mounted EmuNAND USER partition to the "save" folder of the tool.
I double-clicked "run.bat".
All your saves are now located in the "out" directory.
I used a previous Checkpoint saves backup to figure out which folder corresponds to which game, and moved them all in their respective game folder (in the Checkpoint folder of my SD card).
I booted on SysNAND, restored the saves using Checkpoint, and confirmed that they were in working order.
I booted back on the SX Pro bootloader, deleted EmuNAND entirely and created a new Emunand (on firmware 5.1.0 since that's the firmware my SysNAND is on)!
Voilà, if you follow the same procedure I did (and have not burned your fuses because you had enabled AutoRCM before the accidental update), you now have a fully working EmuNAND back on a lower firmware and you can now forget about this whole ordeal!!"
Doesn't say anything about formatting. I did use biskeydump to get it but it says error. When i mount user, it comes up as a drive in windows but when i try to open it to get the saves it says the disk needs formatting. If I format it, won't it delete the dump basically?