Hello! Basically I soldered the wires to the proper contacts, booted up my N3DSXL, and all was AOK until I decided to open the device back up to re-arrange the wiring. While doing this, the TINY CLK contact came up, and I was greeted with the Blue Screen brick once I tried booting again.
I used a silver pen and neatly replaced the contact point, however I'm still getting a blue screen. Is there any way I can fix this?
Thank you.
EDIT:
I fixed the problem by exposing the traces and using THIS silver pen to draw in the connection. I then used the alternate CLK point for the hardmod (found in several places on this board). If need be I can upload photos of the silver contact I made.
I used a silver pen and neatly replaced the contact point, however I'm still getting a blue screen. Is there any way I can fix this?
Thank you.
EDIT:
I fixed the problem by exposing the traces and using THIS silver pen to draw in the connection. I then used the alternate CLK point for the hardmod (found in several places on this board). If need be I can upload photos of the silver contact I made.
Last edited by BanditBat,