- Joined
- Jul 23, 2018
- Messages
- 6,056
- Trophies
- 1
- Age
- 29
- Location
- Lampukistan
- Website
- hmpg.net
- XP
- 6,168
- Country
I installed the driver. But the problem remains. Now the chip is no longer recognized at all. Strange.
I installed the driver. But the problem remains. Now the chip is no longer recognized at all. Strange.
Go to control panel and open device manager and see if it shows as a comport. Also maybe windows isn't assigning a drive letter. You can check that by going to windows administrative tools/computer management/disk management and manually assign a drive letter - then reboot your computer.I installed the driver. But the problem remains. Now the chip is no longer recognized at all. Strange.
I have a problem with my X86 RCM chip.
I've flashed the latest part 1 and part 2 from the OP using the Samd21 update payload.
Part_1_RCMX86_PERMA_CFW_Latest.uf2 first, then the drive resets.
RCMX86_INTERNAL.UF2 the second time.
Now the thing is working fine with the baked in Hekate and all.
But the problem I have is that whenever my switch booted into the Atmosphere CFW, the device isn't recognized in Windows 10.
It only seems to charge now.
The Same happens in Linux, it's unable to initialize.
Could it be that the chip is interfering or something?
Hello,
Today I tried to update my RCM-X86 modchip Switchboot to the latest version but when I connect the Switch to the PC by USB and make the reset of the modchip (double click) it doen´t appear on Windows, despite I hear the sound of connecting and disconnecting the usb.
What can be happening and how can I fix?
Thank you
Try the double click and restarting the switch.
I did, but the same happens, I hear the usb connecting and disconnecting sound but nothing else happens.
Probably bad ground, (D+/D-) soldering, most likely ground. I don't see the point of updating the switchboot on the chip, if it work leave it alone.
I just wanted to keep it updated, I did it a few times a year ago and there was not problem on my pc to recognize it but well, it works fine without updating so I will leave it as it is. Thank you
If you can't get it to work even after double press (resetting the chip) and restarting from horizon OS, it is most likely soldering, according to mattytrog in the past, he stated it has to do with poor ground soldering.
I have tried again restarting from horizon after resetting the chip and it worked! I must have done something wrong before. Thanks a lot!
Pablo, can you compile the newest Hekate? Or give a short guide for that?