Hey!
I just did an installation with a gemma m0, and beside I first soldered the rcm strap wrong, everything is working I guess.
However - I'm not 100% sure I really understand how the dual booting/ autoRCM works:
Everytime I turn on the switch it directly boots to payload.bin.
If I hold VOL+ during boot it first goes to the fusee suite menu.
How can I boot directly to stock now?
EDIT: never mind - got it working. Changed the mode by attached USB to the turned off switch and held VOL+ for about 6 seconds.
It seem the timings are slightly different than on the image of page 1...
I just did an installation with a gemma m0, and beside I first soldered the rcm strap wrong, everything is working I guess.
However - I'm not 100% sure I really understand how the dual booting/ autoRCM works:
Everytime I turn on the switch it directly boots to payload.bin.
If I hold VOL+ during boot it first goes to the fusee suite menu.
How can I boot directly to stock now?
EDIT: never mind - got it working. Changed the mode by attached USB to the turned off switch and held VOL+ for about 6 seconds.
It seem the timings are slightly different than on the image of page 1...
Last edited by bbsan2k,