I have a Switch (was on firmware v6.2) that was working perfectly fine using AutoRCM and booting into Atmosphere. I wanted to update some files on the SDcard so I powered off, copied files over and then put the card back in, injected the payload an boom nothing but a black screen. I tried repeatedly in various ways to boot into the OS and nothing. I would get the Switch logo and then black. I tried different SD cards freshly formatted newer versions of Atmosphere as they came out, all resulted in the same thing. So I left my switch sitting for a few weeks while I had other stuff to do. When I came back to it the battery was completely drained. I charged and to my surprise it actually booted into the OS after injecting hekate. Great I thought. Its come back. I pressed power to put it to sleep and then went to turn it on again and nothing. Just a black screen. Powering off by holding the power button for a while allowed me to get back to the point where I could inject Hekate which runs fine but I still cant boot into the OS.
After many attempts I worked out that the console does boot into the OS BUT!! it will only do it after the battery has been completely drained, then charge the console and on the first attempt after that it boots but putting it to sleep kills it again. To get it to work again the battery needs to be drained again to repeat the process.
Has anyone encountered this?
Oh I should mention that I've now also tried upgrading to the latest firmware when I actually got the console to boot and it installed but the end result is still the same. New OS version also only boots when the console has been full drained and recharged. No fuses were blown when I did the upgrade so I'm still on 8 (6.2) and I have a nand backup of 6.2 which I can put back on. I have also tried just putting the 6.2 backup on but the issue is still there.
After many attempts I worked out that the console does boot into the OS BUT!! it will only do it after the battery has been completely drained, then charge the console and on the first attempt after that it boots but putting it to sleep kills it again. To get it to work again the battery needs to be drained again to repeat the process.
Has anyone encountered this?
Oh I should mention that I've now also tried upgrading to the latest firmware when I actually got the console to boot and it installed but the end result is still the same. New OS version also only boots when the console has been full drained and recharged. No fuses were blown when I did the upgrade so I'm still on 8 (6.2) and I have a nand backup of 6.2 which I can put back on. I have also tried just putting the 6.2 backup on but the issue is still there.