That doesn't work anymore since you use hekate and no one officially makes hekate patches anymore because of stupid drama. You need to force hekate to use fusee-primary so that it will use the atmosphere only sigpatches. On 13, I did:
1. Download from sdsetup
2. Download atmosphere patches
3. Extract both
4. Edit hekate_ipl.ini. change fs0 to payload and set path to fusee-primary.bin (get from atmosphere repo if not in sdsetup zip
ex. payload=bootloader/payloads/fusee-primary.bin
I think this line is also needed:
atmosphere=1 in the config per profile
5. Copy to switch sd
6. Boot via hekate
I read Atmosphere 14 still has issues with the sigpatches that are out. I'd stick with 13 for now.
Ok, thanks for the information, didn't know anything about that.
I followed the steps above, but with the same result. a few questions:
- I have a hekate_ipl.ini in the root of the sd-card as well as in the bootloader subdirectory. I suppose the file in the sub directory is the one used, correct ?
- I downloaded the fusee-primary.bin, copied to the card and edited the ini file.
The switch boots just like it did before, couldn't recognize any difference, is that right ?
That doesn't work anymore since you use hekate and no one officially makes hekate patches anymore because of stupid drama. You need to force hekate to use fusee-primary so that it will use the atmosphere only sigpatches. On 13, I did:
1. Download from sdsetup
2. Download atmosphere patches
3. Extract both
4. Edit hekate_ipl.ini. change fs0 to payload and set path to fusee-primary.bin (get from atmosphere repo if not in sdsetup zip
ex. payload=bootloader/payloads/fusee-primary.bin
I think this line is also needed:
atmosphere=1 in the config per profile
5. Copy to switch sd
6. Boot via hekate
I read Atmosphere 14 still has issues with the sigpatches that are out. I'd stick with 13 for now.
Thanks for the explanation, I didn't know about this.
I copied the fusee-primary to the path you suggested and edited the hekate_ipl.ini file to point to the bin file.
I checked it afterwards, but didn't notice any difference. Also the issues are still the same.
Something else, I use a RCMloader to boot my switch from. this has also got bin files which are used to boot the device. the manual mentions that a payload file has to be called payload.bin. I copied fusee-primary.bin to it and renamed it to payload.bin. but it doen't boot the switch and stays on a black screen.
When I boot the device as I used to (with the RCMloader) I get into hekate v5.3.0 and then I launch the right MCC.
Should the payload on the RCMloader be updated as well ?
Is it possible to boot without RCMloader already ?