I recently had to update the OFW to 12.0.1, so I updated Atmosphere to 0.19.1, and then updated sigpatches accordingly.
Previously, Retroarch 1.9.0 worked just fine, and I was using an NSP forwarder. But ever since, Retroarch refuses to launch. Every other NSP-installed game continues to launch without issue. I have Retroarch installed across two cards, and neither launches RA anymore.
If I try to launch via NSP, I get a generic "The software closed because an error occurred." If I try to launch via Homebrew Album, it crashes Atmos entirely now, and I'm forced to reboot.
I tried replacing the NSP forwarder with the RA 1.9.0 Forwarder found on this site, no change. I tried removing everything in the "retroarch" folder except my sram/save-state folders and thumbnails folder, and then starting with a fresh install from the Libretro website, but again, no change in behavior. Moving the NRO from "switch" to "switch/RetroArch" and back didn't make any difference either.
Oddly enough, I have another SD card with RA set up on it, but it's an entirely different set of games, and I didn't touch the "retroarch" folder yet on this one, and yet it's acting the same exact way as the other card, where I tried to refresh RA from scratch and with an entirely different set of games.
So, I'm stumped! Any suggestions?
Previously, Retroarch 1.9.0 worked just fine, and I was using an NSP forwarder. But ever since, Retroarch refuses to launch. Every other NSP-installed game continues to launch without issue. I have Retroarch installed across two cards, and neither launches RA anymore.
If I try to launch via NSP, I get a generic "The software closed because an error occurred." If I try to launch via Homebrew Album, it crashes Atmos entirely now, and I'm forced to reboot.
I tried replacing the NSP forwarder with the RA 1.9.0 Forwarder found on this site, no change. I tried removing everything in the "retroarch" folder except my sram/save-state folders and thumbnails folder, and then starting with a fresh install from the Libretro website, but again, no change in behavior. Moving the NRO from "switch" to "switch/RetroArch" and back didn't make any difference either.
Oddly enough, I have another SD card with RA set up on it, but it's an entirely different set of games, and I didn't touch the "retroarch" folder yet on this one, and yet it's acting the same exact way as the other card, where I tried to refresh RA from scratch and with an entirely different set of games.
So, I'm stumped! Any suggestions?