Hi, can you give me some advice on usb c replacement please as it seems you have done many.
I have removed a damaged one with my hot air station, cleaned it all up, tinned the pads and cleaned the locator holes, but when I warm it back up and put flux on I can't seem to get the new USB to solder to the board?
I am worried about over heating the board, I have also melted a USB port by assuming I could use the hot air gun on it forgetting its plastic internally.
Any tips would be great thanks.
I have removed a damaged one with my hot air station, cleaned it all up, tinned the pads and cleaned the locator holes, but when I warm it back up and put flux on I can't seem to get the new USB to solder to the board?
I am worried about over heating the board, I have also melted a USB port by assuming I could use the hot air gun on it forgetting its plastic internally.
Any tips would be great thanks.