My v2 is filled with F in SBK, but there are no issues such as being unable to boot into OFW.Before the full stock, I saw that it was normal, not F, but later it became F...
Last edited by handsom_tomato,
My v2 is filled with F in SBK, but there are no issues such as being unable to boot into OFW.Before the full stock, I saw that it was normal, not F, but later it became F...
Not well. The caps are arranged vertically on the v1, horizontally on the v2, so the solder pads are in the wrong spots.Hello guys.
A little question
V1 Flex could work for v2 consoles? Any schematics or image for that?
Thanks in advance.
Enviado desde mi 2107113SG mediante Tapatalk
I would like to quote this response.It's normal that hekate shows sbk as FFF... on mariko.
You need to use 'partial overwrite attack' to dump sbk on mariko, but no reason to do that.
I cut the end and solder to the resistor as well. much simpler
Got a pic of it ?
Use the latest. 2.61Thank you to all who put in so much work. I would like to know if I should be using v2.6 of the firmware from gethub? Will just installing this firmware to the pico allow hekate to run?
noDoes 2.61 need unlock.uf2 ?
Yes once the picofly is setup there is no difference except bugs maybehey since it says hwfly in the title can i just use guides oriented to the hwfly chip
tyAs far as I know
Yes once the picofly is setup there is no difference except bugs maybe
its not terrible if you hav one lying aroundNot well. The caps are arranged vertically on the v1, horizontally on the v2, so the solder pads are in the wrong spots.