Hacking Nintendo Oled can't boot into OFW (after install Hwfly)

[thangga123]

Dear
I am having a problem.

after I installed Hwfly v6. My Oled can't boot to OFW.

A little background on the things that occurred:
1. I can access Boot into hekate (6.0.5) - Atmosphere completely normal. (This file installation version I am still using for many oled).
2. When I choose to OFW. It just shows logo then black screen. I have to hold the power button for 10s to actually turn it off.
3. When I removed the Hwfly chip, the oled booted normally (originally)
4. Perfect welds. I checked with a multimeter and it shows good parameters

I have done many hwfly chip installation before but this problem is a bit difficult for me.

Need help.

Thanks all!

 

[ack]

dude if your welding that chip on your board's gonna be fucking burnt to a crisp lmao

 

[thangga123]

I have replaced another Hwfly chip but still the same error.

 

[thangga123]

hello. Anyone can help me?

 

[leerz]

review cmd resistor value and alignment

 

[Hassal]

Are you using the flex cable for DATA?

To be clear, if you're getting black screen after the logo that's not related to your soldering.

 

[deeps]

for picofly installs, this problem can often be solved by adding some extra resistance on the dat0/cmd points. not sure is hwfly can suffer from the same issue but adding 20-47 ohms extra resistance on those points just to test couldn't hurt.

 

[Bheamut]

I've the same problem, did you manage to resolve it? I'm using a HWFLY 2040, but this happened to me after i moved the D0 adapter. On my first attempt on the installation it was starting cfw and ofw normaly but sometimes it could not read D0 so i moved the adapter.