Misc Nds WiFi settings? WEP or ?

  • Thread starter Thread starter Ringo619
  • Start date Start date
  • Views Views 13,538
  • Replies Replies 67
Ugh so I went to the Nintendo site, and found the settings for my router that I needed to set and did them. Except for the TX rate that needs to be 2. My router has no setting that allows the TX rate to be changed, yet Nintendo's site says it does. What do I do?
 
bigllama99 said:
Ugh so I went to the Nintendo site, and found the settings for my router that I needed to set and did them. Except for the TX rate that needs to be 2. My router has no setting that allows the TX rate to be changed, yet Nintendo's site says it does. What do I do?
TX rate means BPS, something you should NOT adjust. Where does it say it needs TX to be 2?
 
trumpet-205 said:
bigllama99 said:
Ugh so I went to the Nintendo site, and found the settings for my router that I needed to set and did them. Except for the TX rate that needs to be 2. My router has no setting that allows the TX rate to be changed, yet Nintendo's site says it does. What do I do?
TX rate means BPS, something you should NOT adjust. Where does it say it needs TX to be 2?


It says here.
http://www.nintendo.com/consumer/wfc/en_na...s/DLink/all.jsp

QUOTE
Important Notes:
DS

Change the "TX rate" setting to "2." This is usually located in the "advanced" section of your router settings, under "performance."
Change the wireless channel to 1 or 11. This setting can be found under 'Wireless Settings' on the 'Basic Settings' page.
 
Set authentication to Auto

Also to be clear TX means transmission rate (wireless speed in a sense, aka bits per second). 2Mbps is way too slow. If you set it to 2 it will slow down the entire network dramatically.

Also can you set it so it is only b/g mixed?
 
Try saving all the correct settings, turn off / unplug the router, turn off your DS, count to 10 slowly, plug the router back in, turn on your DS and play.
 
Ok guys i need help on this too.
I trying to set up my wi-fi.
I've tried before at this but failed.
But this time i choose ''Auto-Obtain IP Address'' to NO
OK so so far i've done the SSID
WEP KEY
''Auto-Obtain IP Address''
IP ADDRESS...
Next is the Subnet Mask...Whats that??
 
Rydian said:
Just use 255.255.255.255, and if that doesn't work use 255.255.255.0.
I got it to work.
I know what the problem was.
It was the WEP key when i went to my Moderm page the security code was in WPA.
And you need WEP to acces WI-FI so i changed it but then i couldnt connect to the internet on my laptop or computer
but i could connect on the Wii,NDS all the other consoles.
So my question is can i go on my Laptop.etc and My NDS,etc. at the sametime?How?
 

Site & Scene News