I've installed picofly on a new working OLED.
I was very careful to protect every solder point to prevent shorts etc.
After installation, I was so surprised to find that although I can boot into hekate but it shows the battery is 0% and 0 amp current.
I suspected max 17050 is dead and did two replacements with no luck to recover. (not sure the new chip is ok or not).
The strange thing is why the installation can cause 17050 dead? so strange. anyone had the same issue?
in hekate, it shows like something below:
I was very careful to protect every solder point to prevent shorts etc.
After installation, I was so surprised to find that although I can boot into hekate but it shows the battery is 0% and 0 amp current.
I suspected max 17050 is dead and did two replacements with no luck to recover. (not sure the new chip is ok or not).
The strange thing is why the installation can cause 17050 dead? so strange. anyone had the same issue?
in hekate, it shows like something below: