Hi all,
I have a v1 Switch that had the 1-bit mode error. I found the missing pins, and successfully added a jumper wire from the board to the SD card reader which resolved the problem. However, I didn't secure the connection on the board well enough, and the wire popped off taking the solder pads with it (Image attached). Do I have any options here other than replacing the whole collector?
Thanks for any & all help!
I have a v1 Switch that had the 1-bit mode error. I found the missing pins, and successfully added a jumper wire from the board to the SD card reader which resolved the problem. However, I didn't secure the connection on the board well enough, and the wire popped off taking the solder pads with it (Image attached). Do I have any options here other than replacing the whole collector?
Thanks for any & all help!
