Hi,
I tried to install a modchip on my Core v2 switch earlier today.
After putting everything together following the instructions and turning the device on to test, I get a single blue blink for 1 second, followed by one single purple pulse. After the purple pulse, the modchip LED goes off while the switch itself has a black screen. The backlighting stays on for about 1 minute, and then the switch turns off completely.
When starting the switch again after that, it follows the same patterns.
I don't have much experience with soldering/electronics, however, I do have a multi-meter if anyone would be able to guide me through some further troubleshooting.
All help is appreciated, I hope I did not break my switch.
I tried to install a modchip on my Core v2 switch earlier today.
After putting everything together following the instructions and turning the device on to test, I get a single blue blink for 1 second, followed by one single purple pulse. After the purple pulse, the modchip LED goes off while the switch itself has a black screen. The backlighting stays on for about 1 minute, and then the switch turns off completely.
When starting the switch again after that, it follows the same patterns.
I don't have much experience with soldering/electronics, however, I do have a multi-meter if anyone would be able to guide me through some further troubleshooting.
All help is appreciated, I hope I did not break my switch.