After Installation of Instinct nx v6 (white), I get purple screen.
Power On via Power Button does not work, only when USB Charge connected the Console turns on, then screen turns purple (With or without modchip top ribbon cable connected).
The two capacitors at the apu which normally should be connected to the ribbon, are missing. according to the forum they are not required.
I have tested the pins on the modchip they all give me the values between 0.5V and 0.8V. B Pin gives me no Beep.
I measured the resistor at CMD, gives me 0.3v and 0.7v.
There is one trace which got broken near apu, bottom left corner (there where you have to cut the shield. This trace i have bridged but i am not 100% sure whether traces in lower layers got damaged too (i did see some copper but i did isolate it). i did test the bridge. Could it be the APU Trace or where to look next?
OLED, certainly latest firmware.
Now it did boot, though it makes some coil noises, but into ofw and immediately failed (an error occurred 2101-0002). i tried to power off, does not work. only plugging off battery worked.
Power On via Power Button does not work, only when USB Charge connected the Console turns on, then screen turns purple (With or without modchip top ribbon cable connected).
The two capacitors at the apu which normally should be connected to the ribbon, are missing. according to the forum they are not required.
I have tested the pins on the modchip they all give me the values between 0.5V and 0.8V. B Pin gives me no Beep.
I measured the resistor at CMD, gives me 0.3v and 0.7v.
There is one trace which got broken near apu, bottom left corner (there where you have to cut the shield. This trace i have bridged but i am not 100% sure whether traces in lower layers got damaged too (i did see some copper but i did isolate it). i did test the bridge. Could it be the APU Trace or where to look next?
OLED, certainly latest firmware.
Post automatically merged:
Now it did boot, though it makes some coil noises, but into ofw and immediately failed (an error occurred 2101-0002). i tried to power off, does not work. only plugging off battery worked.
Last edited by CidHighwind1994,