Hacking Instinct-NX V6S Oled not working (Putty: BAD00107, Led Redx2 ,Multiple Blue,OFW)

[lumifox]

Cant find anyone having the same issue as this anywhere so diagnosing is a nightmare

Its not matching any of the color diagnostics codes i can find online (Redx2, Multiple Blue flashing - Boots to OFW)

Did kamakazi method and severed a trace (wasn't powering at all) but used the same wire to reconnect both so i know for sure its connected

Attempted to reflash the chip and its still doing the same thing (Putty reset/sthetix firmware download link)

can only find one thread with a similar issue and theirs was "dat ok:no" in putty

Putty gives me

Glitching failed, no eMMC communication observed.

SoC detection successful:

eMMC CLK ok: yes

eMMC CMD ok: yes

eMMC DAT ok: yes

eMMC PKT ok: yes

SoC type: Mariko

Device voltage:

Erista rails: 978

Mariko rails: 1616

Glitcher fatal: console RST failure

# Diagnose status: BAD00107 (ERR_UNKNOWN_DEVICE)

# Please make sure console is powered on

Do i just give up and get a picofly?

 

[SudoRoot]

Not sure whether you fixed it already, but the issue is with point B (RST); it even says so in the diagnostic ("Glitcher fatal: console RST failure").

But tbh, I came across two V6S units that were defective and claimed the same, but with another V6S unit, it worked right away.