chinese m3 simply to english

Discussion in 'M3 Adapter' started by joeschmoe, May 14, 2007.

May 14, 2007
  1. joeschmoe
    OP

    Newcomer joeschmoe Member

    Joined:
    May 14, 2007
    Messages:
    19
    Country:
    United States
    The title says it all. What do I need to do to change my chinese m3 simply to English? I read somewhere that a little soldering is involved: this is not a problem. But what do I solder?
    EDIT: Ok I found the guide on afterdawn but now I'm looking for confirmation that the newest batches can still be switched back and forth. I have a silver "PASS 03/04" sticker on the solder bridge next to the ic.
    EDIT #2: I did it, it works fine. I had to add a small piece of solid wire over the points since the solder didn't want to bridge over.

    So I answered my own question.
     

Share This Page