I installed the HBC a long time ago, and since then my Wii has been updated, so my system menu is 4.0E as far as I know.
I'm fairly new to the whole homebrew thing, but I set out to install USB Loader GX anyway.
What I first gathered was that I needed a cIOS installed, so I got cios38rev13 installer, and ran it, choosing ios38 (I wasn't sure what to use)
and selecting WAD installation, causing it to find IOS38-64-v3610.wad on the root of my SD card.
I have the latest revision (517 or something like that) of USB Loader GX and when I try to run it from the HBC I get a black screen and the Wiimote turns off.
There is nothing wrong with the Wii itself, it still hard resets and I can get back to the system menu.
Any ideas?
I know I missed something, just don't know what because I'm a bit of a noob at this.
I'm fairly new to the whole homebrew thing, but I set out to install USB Loader GX anyway.
What I first gathered was that I needed a cIOS installed, so I got cios38rev13 installer, and ran it, choosing ios38 (I wasn't sure what to use)
and selecting WAD installation, causing it to find IOS38-64-v3610.wad on the root of my SD card.
I have the latest revision (517 or something like that) of USB Loader GX and when I try to run it from the HBC I get a black screen and the Wiimote turns off.
There is nothing wrong with the Wii itself, it still hard resets and I can get back to the system menu.
Any ideas?
I know I missed something, just don't know what because I'm a bit of a noob at this.