told you that you don't need hekate at all, because it's all made to work with each other.Oh! It worked! It wrote the keys to the sdcard
told you that you don't need hekate at all, because it's all made to work with each other.Oh! It worked! It wrote the keys to the sdcard
You are right, sorry for being dumb.told you that you don't need hekate at all, because it's all made to work with each other.
You can actually try SX payload and try it that way.You are right, sorry for being dumb.
Was there some other way to make the backup just in case?
How does the SX work, do I need to buy somthing or is it like hekate?You can actually try SX payload and try it that way.
Or setup hackdisckmount and just coppy/dump everything (idk how tho).
Have you found any way around it? Did it work before and suddenly stopped or has it never worked?i ahve same problem by my switch
new memloader bundled with tegra
[MTC_LOAD] Error during lzma decompressions, got 0 instead of 4294967295 bytes out !
I'm trying to get broken Switch from ebay back to working. If I try to turn on it normally it just shows blue screen. I did the rcm hack by soldering two pins together inside switch (joycon connector thingy). Now I can boot hekate v3, but the CTCaer will only show black screen. (I use TegraRcmSmashgui)
If I try to make backup in to the sd card I will get fsfat error 13 no fat partition with the Hekate v3.
I have replaced SD card connectors inside switch and they seem to connect just fine when measured.
I tested with kingston 4gb sdhc, samsung evo 64gb sdxc and kingston 64gb sdxc (both exfat and fat32) none of them worked. And sometimes if I had exfat on sd card and tried to send payload from pc switch would only show black screen and not launch hekate.
I really apperciate if someone could help!
from what I read the sd card reader might have popped out